Frymaster H14 Bedienungsanleitung PDF herunterladen (Seite 17)

4-5

2. Install the Power Shower (if the fryer is so

equipped).

Remove the basket support rack from the frypot,

raise the element assembly to the up position,

and snap the Power Shower into position.

DANGER

DO NOT operate the filter without the Power Shower in place unless unit is

configured with a rear flush option. Hot oil will spray out of the fryer and may cause

injury.

4. After all oil has drained from the pot, turn the

filter handle to ON to start the pump and

begin the filtering process. (For units

equipped with a rear-flush option, position

the control lever to either the Power Shower

or Rear Flush position.) There may be a slight

delay before the pump activates.

5. The filter pump draws the cooking oil/shortening through the filter and circulates it back up to

and through the fryer during a 5-minute process called polishing. Polishing cleans the oil by

trapping solid particles in the filter medium.

6. After the oil is filtered (about 5 minutes), close the drain valve and allow the fryer to refill. Let

the filter pump run 10 to 12 seconds after bubbles appear in the oil (or it begins to sputter from

the Power Shower on fryers so equipped). Turn the filter off (and remove the Power Shower and

let it drain, if so equipped).

INTERNATIONAL KESSEL SERVICE

WWW.INTERNATIONALKESSEL.COM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Keine Kommentare

Frymaster H14 Bedienungsanleitung Seite 17