Frymaster H14 Bedienungsanleitung PDF herunterladen (Seite 29)

6-6

Problem Probable Causes Corrective Action

CM III

or

Digital Controller

display shows

.

Frypot temperature is more than 21ºF

(12ºC) below setpoint.

This display is normal when the

fryer is first turned on and may

appear for a short while if a large

batch of frozen product is added to

the frypot. If the display never

goes out, the fryer is not heating.

Look for a decimal in the LED

display between digits 1 and 2. If

the decimal is present, the

computer is calling for heat and is

functioning properly. See Fryer

Does Not Heat in Control and

Heating Problems (Section 6.2.1).

If the decimal is not present, the

computer is not calling for heat and

may be malfunctioning. If

available, substitute a controller

known to be working for the

suspect computer. If the fryer

functions correctly with the

substitute computer, order a

replacement computer from your

FASC.

CM III

or

Digital Controller

display shows

.

Problem with the temperature

measuring circuitry including the

probe.

This indicates a problem within the

temperature measuring circuitry

that is beyond the scope of

operator troubleshooting. Shut the

fryer down and call FASC.

CM III frypot

temperature is

displayed constantly.

Computer is programmed for

constant temperature display.

The CM III computer may be

programmed for constant

temperature display or countdown

timer display. Refer to the separate

Frymaster Fryer Controllers

User's Manual for instructions on

toggling between these display

options.

Solid state controller

trouble light ON.

Oil temperature above acceptable

range or a problem with the

temperature measuring circuitry.

This in an indication of a

malfunction in the temperature

measuring or control circuitry,

including a failure of the high-limit

thermostat. Determining the

specific problem is beyond the

scope of operator troubleshooting.

Shut the fryer down immediately

and call FASC.

INTERNATIONAL KESSEL SERVICE

WWW.INTERNATIONALKESSEL.COM

1 2 ... 24 25 26 27 28 29 30 31 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare